Source-audio Soundblox 2 OFD Bass microModeler Manuel d'utilisateur télécharger pdf (Page 20)

20 | Use with Hot Hand

USE WITH HOT HAND

All Soundblox pedals are compatible with our Hot Hand accessories. Hot

Hand units consist of a ring mounted accelerometer that is used to detect

motion for controlling effect parameters. On the Soundblox 2 OFD Bass

microModeler, a Hot Hand unit can be connected to the Multi-Function

input. To enable Hot Hand, select the HH mode as the external control

option. This will take the input signals for the Hot Hand unit and use them

to control either the Morph or whichever parameter has been selected.

The SB2 OFD Bass can also be calibrated to change the midpoint of the

Hot Hand control range. To do this, follow the calibration procedure below.

Note that Calibration is only used for Hot Hand mode and calibration is

NOT required before use.

To perform a calibration:

1. Select a preset by pressing a footswitch.

2. Enable Hot Hand control by selecting HH mode from the external

controls.

3. Press and hold the NOISE GATE button until the HH red LED begins to

blink slowly (this is the same as the control assign procedure.

4. Put the Hot Hand sensor into the desired calibration position.

5. Press the footswitch for the currently selected preset.

6. The Calibrate LED will blink to when the calibration is complete.

If you have trouble with calibration and need to get back to the default

setting, point the front of the sensor (the H logo) straight up towards the

ceiling and run the calibration procedure again.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Source-audio Soundblox 2 OFD Bass microModeler Manuel d'utilisateur Page 20