Source-audio Soundblox 2 OFD Bass microModeler Manuel d'utilisateur télécharger pdf (Page 18)

18 | External Control

The same process can be used for either EXP or HH modes. To return to

the default morph control, set the external control to OFF, and then press

and hold the NOISE GATE button again until all three LEDs blink rapidly.

MORPHING

The Multi-Function control input can be used to morph between the two

presets. For example, let’s say preset 1 is saved as a low drive SMOOTH

TUBE setting and preset 2 is a high drive OCTAVE FUZZ setting. By

connecting an SA161 Expression Pedal, you can fade from the preset

1 normal sound into the octave effect saved in Preset 2 by rocking the

expression pedal from heel to toe. As you fade between the sounds, the

two footswitch LEDs will change brightness depending on where you are

in the transition.

Morphing is not a cross fade between two sounds but rather a gradual

shift between all of the individual parameters. So the middle of expres-

sion pedal range is truly an “in-between” sound.

There are 144 possible pair combinations of OFD effects and some will

sound better than others. Some obvious applications are morphing

from clean to distorted sounds, low drive settings to high drive settings,

changes in volume, or between dramatically different sounds.

The expression pedal can be effectively inverted depending on which

preset is initially enabled. This will toggle start and stop presets for the

pedal. Keep in mind that adjusting knobs while using the expression

pedal will only control the originally selected preset, independent of the

expression pedal position. Also, while tweaking presets to get the desired

pair of sounds for morphing, don’t forget to save before switching to the

other preset.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Source-audio Soundblox 2 OFD Bass microModeler Manuel d'utilisateur Page 18