Source-audio Soundlbox 2 Orbital Modulator Manuel d'utilisateur télécharger pdf (Page 15)

14 | Controls: Footswitches

CONTROLS: FOOTSWITCHES

There are two footswitches on the Orbital Modulator. The left footswitch

corresponds to preset 1 and the right footswitch corresponds to preset

2. Pressing either of the footswitches will engage the respective preset.

Pressing the same footswitch again will put the effect back into bypass

mode. Pressing the other footswitch will engage the other preset without

going into bypass. The illumination of the LEDs labeled “1” and “2”

indicate which preset is currently enabled. While the effect is in bypass

mode both LEDs remain off.

When a preset is enabled and any sort of adjustment is made, the

indicator LED for that preset will begin to blink, showing that the preset

has been edited. After a preset has been edited, save it by pressing and

holding either footswitch. The corresponding LED will blink quickly to

indicate that the preset has been saved. Once changes are saved, the LED

will illuminate continuously. An edited preset can be saved to either of

the two preset locations. For example if preset 1 has been selected and

edited, it can be saved to preset location 2 by pressing and holding the

right footswitch.

Note: Changes made to a preset will be lost if you go into bypass or

switch to another preset without saving.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Pas de commentaire

Source-audio Soundlbox 2 Orbital Modulator Manuel d'utilisateur Page 15