Source-audio Soundblox Pro Multiwave Distortion Pro Manuel d'utilisateur télécharger pdf (Page 11)

Backpage Parameters | 2120 | Use with Hot Hand

BACKPAGE PARAMETERS

The MWD Pro has some additional controls that can only be editing

in a special mode called Backpage mode. Backpage mode is enabled

by pressing the

HH ENABLE and CALIBRATE buttons simultaneously, as

indicated on the main control panel. Backpage mode can be exited by

pressing the two buttons simultaneously again.

In Backpage mode, the

EQ controls and the Effect knob take on different

functions and the displays will change to indicate the parameter values.

For the

EQ display, there are two letter abbreviations above some of the

columns that indicate the parameter controlled in Backpage mode. Select

the parameter to be edited with the left and right band select buttons

and adjust the value with the knob.

HH Enable

The

HH ENABLE button will allow Hot Hand

control for an individual

preset so it can be used on one preset and not on another.

Calibration

The

MWD Pro has a calibration feature which is only used in Hot Hand

mode. However, calibration is not required before use. The calibration

feature allows you to set the

MAXIMUM point of the DRIVE sweep for any

position of your hand. Depending on your playing style, you may nd it

useful to try some different calibration positions. The default and most

common use of calibration is to have your hand pointing straight up as

the maximum point of the

DRIVE sweep. Calibration can also be useful

if you are putting the sensor on a headband or other alternate locations.

Calibration mode can only be enabled when

HH ENABLE in ON. Calibra-

tion settings are saved per preset.

To perform a calibration:

1. Select a preset by pressing a footswitch.

2. Enable Hot Hand control by pressing the

HH ENABLE button.

3. Press the

CALIBRATE button to put the MWD Pro into Calibrate Mode.

4. Put the Hot Hand sensor into the desired calibration position.

5. Press the footswitch for the currently selected preset.

6. The Calibrate

LED will blink to when the calibration is complete.

If you have trouble with calibration and need to get back to the default

setting, point the front of the sensor (the H logo) straight up towards the

ceiling and run the calibration procedure again.

125 250 500 1K 2K

(NG) (HG) (HS) (HA) (HR) (CR)

4K 8K

+12

-12

< >

+12

-12

HH ENABLE

CALIBRATE

BACKPAGE

MODE

- Continued

1 2 ... 6 7 8 9 10 11 12 13

Commentaires sur ces manuels

Pas de commentaire

Source-audio Soundblox Pro Multiwave Distortion Pro Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Source-audio Soundblox Pro Multiwave Distortion Pro