USER’S GUIDESA115Universal Wireless Effects Controller
Selecting an output modeThe Hot Hand 3 Receiver can output a total of three control signals: two on the Sensor Output and one on the Expression Output
Selecting an output mode | 11As the MODE LED blinks, press the CALIBRATE button again to scroll through the six output modes. The LED colors of the
12 | Notes on using multiple units / Configuring the expression output Notes on using multiple unitsThe Hot Hand 3 Universal Wireless Effects Control
• Line 6 mode is a special setting for use with Line 6 effects units and stompboxes. Note: Unlike most expression inputs, this mode uses a normal
14 | Status LEDs and troubleshooting LED State DescriptionRing LED — fast blink Ring is being charged.Ring LED — slow blink Ring is trying to fin
Warranty | 15LIMITED WARRANTYSource Audio, LLC (hereinafter “Source Audio”) warrants that your new Source Audio Hot Hand 3 Universal Wireless Effec
and repairs of Source Audio products are to be performed only at the Source Audio factory or a Source Audio authorized service center. Prior to servic
2 | Welcome WelcomeThank you for purchasing this Hot Hand 3 Universal Wireless Effects Controller. We hope that the new functionality of the Hot Han
Charging the ring | 3Charging the ringBefore using your new Hot Hand 3 Universal Wireless Effects Controller you should fully charge the ring batte
4 | Connections ConnectionsThe receiver can be connected to any effects pedal that has the ap-propriate input jacks. This includes the Sensor Input o
1⁄4-inch Expression Cable (TRS)Connecting a Third-Party pedal Connections | 5Connecting a Soundblox® pedalHot Hand 3ReceiverDC AdapterSoundblox® Ped
6 | ConnectionsConnecting Soundblox® and Third Party pedals1⁄8-inch Sensor Cable1⁄4-inch Expression Cable (TRS)Hot Hand 3ReceiverSoundblox® PedalThi
Using the wireless ring | 7Using the wireless ringOnce the ring is fully charged and the receiver is powered, you can turn on the ring. Gently pres
8 | Adjustments AdjustmentsMost Source Audio Soundblox pedals have built-in controls for adjust-ing the Hot Hand input, however, some do not and it
Calibration | 9CalibrationCalibration is used to set the control output level when the ring is in the middle of its range. Depending on your set up
Commentaires sur ces manuels